Reading The Display - Facom 711 Notice D'instructions

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 4

Reading the display

The sign concerned lights up when the function is active.
-
+
Battery condition
MIN
Reads the minimum value noted during the last test
MAX
Reads the maximum value noted during the last test
HOLD
The last value has been saved.
RANGE
Range selection is in the manual mode
~
The measurement in progress on AC
...
The measurement in progress on DC
The diode tester function is active
The continuity test mode is active
MkΩHz
The measurement units sign is active
The figures give the value in the measurement units
The bar graph shows the same value.
Connecting the wires to the tester
Insert the jack on the black wire in the hole marked «COM».
Insert the red jack in the hole ringed in red and marked «+».
When measuring high currents
Insert the red jack in the hole marked «10A».
16
(the beep is activated).

Publicité

Table des Matières
loading

Table des Matières