Facom 711 Notice D'instructions page 15

9 function switch 9 function switch 9 function switch
9 function switch 9 function switch
OFF = Off position
V = Voltmeter
10 MΩ Ω Ω Ω Ω
V élec
= DC
270 kΩ Ω Ω Ω Ω
Hz = Measurement of frequencies up to 400 kHz
• / Ω Ω Ω Ω Ω = Audible continuity test for resistances up to R ≤ 40 Ω Ω Ω Ω Ω , and resistance
measurement up to 40 MΩ Ω Ω Ω Ω . The continuity test is selected
automatically on switching on.
= Diode test. Measures the junction voltage in the forward direction,
and battery condition on an open circuit.
= C meter up to 40 µF
mA
= Ammeter up to 400 mA
The automatic mode is selected on switching on.
10A = Ammeter up to 10 A
Additional function keys
...
/~ to switch from AC
or current.
•
to switch from ohmmeter to continuity tester or vice versa when
Ω/ Ω/ Ω/ Ω/
Ω/
measuring resistance or continuity.
to read, alternately, the minimum and maximum values obtained in
MIN/MAX
voltmeter, ammeter, ohmmeter and frequency tester functions.
to select, alternately, measuring ranges within a function in the
RANGE
automatic or manual mode.
to light the display, if necessary, for 5 minutes.
to save the last measurement taken on the display
HOLD
(saves the batteries)
...
or AC ~ ~ ~ ~ ~ )
(DC
...
or AC ~ ~ ~ ~ ~ voltmeter up to 600 Volts with low impedance :
~ to DC
up to 600 Volts with high impedance :
...
and ~ ~ ~ ~ ~
(via the + terminal)
...
and ~ ~ ~ ~ ~
(via the 10 A terminal)
...
or vice versa, when measuring voltage
(digital and bar graph)
.
15