Safety Notices; Causes And Rectification Of Faults - CASO DESIGN EMCG 32 Mode D'emploi

17.1 Safety notices

Attention
► Only qualified electricians, who have been trained by the manufacturer, may carry out
any repairs on electrical equipment.
► Improperly performed repairs can cause considerable dangers for the user and
damages to the device.

17.2 Causes and rectification of faults

The following table assists in localizing and rectifying minor faults.
Error
The selected program will
not start.
The turntable turns jerkily.
Food is not sufficiently
defrosted, warmed up or
cooked after preset time
has elapsed.
The device functions but
the cooking chamber
lighting does not work.
Abnormal noises can be
heard during operation of
microwave.
The time in the display
field is not correct.
Please note
► If you are unable to solve the problem with the steps shown above, please contact
Customer Service.
Possible cause
Device door is not closed
Power plug is not plugged in
Fuse is not activated
Dirt between the turntable and
the base of cooking camber
Dirt on rolling ring
Cooking vessel too large
Incorrectly selected time or
power level
Defective cooking chamber
light.
Food is covered with
aluminium foil
The cookware contains metal
and sparks are being created
within the cooking chamber
Power failure
Action
Close device door
Plug in mains plug!
Activate fuse
Remove dirt
Use different cooking
vessel
Re-set time and power
level
Repeat process
Have Service dept repair
cooking chamber light.
Remove aluminium foil
Observe information on
cookware!
Re-set time
78