Troubleshooting; Safety Notices; Fault Indications - CASO DESIGN MCG30 Chef Manuel

 Rotating plate and rolling ring
 The glass turntable must be removed and cleaned occasionally. Wash the plate in a
warm soapy solution or in the dishwasher.
 The rolling ring should be cleaned regularly to prevent excessive noise development or
a rotational malfunctions.
The rolling ring can be washed in a mild soapy solution or in the dishwasher. Please
remember to put the rolling ring back again properly after cleaning it.
 Wipe the bottom of the oven with a mild cleaning agent. If the floor of the oven is
excessively dirty, you can use a mild cleaning agent.

15 Troubleshooting

This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:

15.1 Safety notices

Attention
► Only qualified electricians, who have been trained by the manufacturer, may carry out
any repairs on electrical equipment.
► Improperly performed repairs can cause considerable dangers for the user and
damages to the device.

15.2 Fault indications

In the event of a fault, an error code will appear in the display; it describes the cause of the
fault.
Error code Description
E-01 Excessive temperature within cooking chamber
The overheating cut-out terminated the current program at a cooking
chamber temperature of 300°C.
Press the Stop button to acknowledge this fault.
The device can be re-activated after the cool down phase.
E-03 Sensor fault
The device has detected an error on a sensor and has terminated the
current programme.
Press the Stop button to acknowledge this fault.
Please note
► If error messages continue to appear after an extended waiting period and restarting the
device, then the device will need to be sent to Customer Service to be inspected.
caso MCG30 Chef (pure white, black) 69