Troubleshooting; Safety Notices; Causes And Rectification Of Faults - CASO DESIGN BMG 20 Mode D'emploi Original

 Front of device and operating panel

Clean the front of the device and the operating panel with a soft, slightly damp cloth.

Please bear in mind that the operating panel does not get wet. Use a soft, damp cloth
for cleaning.
► Leave the oven door open to prevent the device from being re-started accidentally.
 Exterior housing

Clean the exterior surfaces of the device with a damp cloth.
 Metal rack and base plate
The metal rack occasionally needs to be cleaned. Wash the metal rack in a warm soap
solution. Wipe the bottom of the oven with a mild cleaning agent. If the floor of the oven is
excessively dirty, you can also use a mild cleaning agent.

15 Troubleshooting

This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:

15.1 Safety notices

► Only qualified electricians, who have been trained by the manufacturer, may carry out
any repairs on electrical equipment.
► Improperly performed repairs can cause considerable dangers for the user and
damages to the device.

15.2 Causes and rectification of faults

The following table assists in localizing and rectifying minor faults.
Error
The selected program will
not start.
Food is not sufficiently
defrosted, warmed up or
cooked after preset time
has elapsed.
Please note
Attention
Device door is not closed
Power plug is not plugged in
Fuse is not activated
Incorrectly selected time or
power level
Possible cause Action
Close device door
Plug in mains plug!
Activate fuse
Re-set time and power level
Repeat process
66