Avoiding Radio Interference; Assembling The Accessories; Glass Turntable - CASO DESIGN EMCG 32 Mode D'emploi

► If you use your appliance at a height of 900 mm or more above the floor, please
ensure that the turntable does not shift when you remove your food / container. There
is a danger of injuries!

13.5.4 Avoiding radio interference

The device can cause the occurrence of interference in radios, televisions or similar
devices.
Such faults can be rectified or reduced as a result of employing the following measures:
• Clean the door and the sealing surfaces of the device.
• Set the radio, the television, etc as far as possible away from the device.
• Connect the device to a different electrical outlet, so that various power circuits are
used for the device and the receiver with the interference.
• Use a properly installed antenna for the receiver, to ensure good reception.

13.6 Assembling the accessories

13.6.1 Glass turntable

1 Hub (underside)
2 Glass turntable
3 Turntable drive
4 Rolling ring
Assemble the glass turntable as follows:
• Insert the rolling ring
• Place the glass turntable inside the appliance so that the grooves on the underside
of the glass dish lock into the turntable drive.
• Never place the glass tray inside the appliance upside down; it must be able to
revolve freely.
• When cooking always use the glass turntable and the matching rolling ring.
• Always place all food and containers on the glass turntable or the grating for grilling.
• In case the glass turntable or the rolling ring crack or break please contact your
Service Centre.
Open the door; fix the oven to the cabinet
with screw at the installation hole. Then fix
the trim-kit plastic cover (1) on the screw (2)
in the installation hole (3).
Please note
► Install or locate this oven only in
accordance with the installation
instructions provided.
► The outside surfaces of the cabinet may
get hot.
62