Ce-Konformitätserklärung - Cherry G86-6 Serie Mode D'emploi

Data and Certifications
1 Technical data
Designation
Interface
Supply voltage
Current consumption
Storage temperature
Operating temperature
Cable length
2 Certifications
2.1 CE-Konformitätserklärung
Wir, ZF Electronics GmbH, erklären, dass die
Tastaturen der Serie G86-6x4xx (SPOS) mit
folgender Anforderung übereinstimmen:
• EMC-Richtlinie (Richtlinie zur elektromagnetischen
Verträglichkeit) 2004/108/EC, geprüft nach
EN 55022 und EN 55024
Getestet gemäß ZF Electronics-Standard-
Testverfahren.
CE Declaration of Conformity
We, ZF Electronics GmbH, hereby declare that the
keyboards of the serie G86-6x4xx (SPOS) are in
conformance with:
• EMC Directive 2004/108/EEC (directive on
electromagnetic compatibility), tested in
accordance with EN 55022 and EN 55024
Tested in accordance with ZF Electronics standard
test procedure.
Déclaration de conformité CE
Nous, ZF Electronics GmbH, déclarons que les
claviers de la série G86-6x4xx (SPOS) sont
conformes aux exigence suivante:
• Directive CEM (directive sur la compatibilité
électromagnétique) 2004/108/CEE, contrôle
suivant EN 55022 et EN 55024
Testé suivant la procédure d'essai standard de
ZF Electronics.
8
Value
USB 2.0 (Full-speed
composite device)
5.0 V/DC ±5 % SELV
max. 100 mA
–20 °C ... +60 °C
0 °C ... +50 °C
Approx. 1.85 m
2.2 Federal Communications Commission
(FCC) Radio Frequency Interference
Statement
Information to the user: This equipment has been
tested and found to comply with the limits for Class B
digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may
cause harmful interference to radio communications.
However, there is no guarantee that interference will
not occur in a particular installation. If this equipment
does cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to
correct the interference by one or more of the
following measures:
• Reorientate or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/
TV technician for help.
Caution: Any changes or modifications not expressly
approved by the party responsible for compliance
could void the user's authority to operate the
equipment.
2.3 For UL
For use with Listed Personal Computers only!