Work Clamp - Ryobi TS1143L Manuel D'utilisation

DUST BAG
See Figure 10.
A dust bag is provided for use on the miter saw. It fits over the
exhaust port on the upper blade guard. Squeeze the two metal
clips to open the mouth of the bag and slide it on the exhaust
port. Release the clips. The metal ring in the bag should lock
in between the grooves on the exhaust port. To remove the
dust bag for emptying, simply reverse the above procedure.

WORK CLAMP

See Figure 11.
WARNING:
In some operations, the work clamp assembly may
interfere with the operation of the blade guard assembly.
Always make sure there is no interference with the blade
guard prior to beginning any cutting operation to reduce
the risk of serious personal injury.
The work clamp provides greater control by clamping the
workpiece to the fence. It also prevents the workpiece from
creeping toward the saw blade. This is very helpful when
cutting compound miters. Depending on the cutting operation
and the size of the workpiece, it may be necessary to use a
C-clamp or other suitable clamp instead of the work clamp to
secure the workpiece to the miter table prior to making the cut.
To install the work clamp:
 Place the shaft of the work clamp in either hole on the
miter table base.
 Rotate the knob on the work clamp clockwise to move it
in or counterclockwise to move it out as needed.
TO INSTALL/REPLACE THE BLADE
See Figures 12 - 13.
The blade is shipped installed on this miter saw model.
Instructions have been included for reference when changing
or replacing blades.
WARNING:
A 7-1/4 in. blade is the maximum blade capacity of the
saw. Never use a blade that is too thick to allow outer
blade washer to engage with the flats on the spindle.
Larger blades will come in contact with the blade
guards, while thicker blades will prevent the blade bolt
from securing the blade on the spindle. Either of these
situations could result in a serious accident and can
cause serious personal injury.
 Unplug the saw.
 Raise the saw arm.
 Using the phillips screwdriver end of the blade wrench,
loosen, but do not remove, the blade bolt cover screw.
Rotate lower blade guard and blade bolt cover up and
back to expose the blade bolt.
ASSEMBLY
EXHAUST
PORT
BASE
SPINDLE
LOCK BUTTON
15 - English
DUST
BAG
WORK
CLAMP
Fig. 10
Fig. 11
Fig. 12