Mounting Holes - Ryobi TS1143L Manuel D'utilisation

WARNING:
This saw can tip over if the saw head is released suddenly
and the saw is not secured to a work surface. ALWAYS
secure this saw to a stable work surface before any use
to avoid serious personal injury.

MOUNTING HOLES

See Figure 7.
WARNING:
Before starting any cutting operation, clamp or bolt
your miter saw to a workbench or an approved miter
saw stand. If a miter saw stand is used, read operator's
manual and follow the instructions for the miter saw
stand. Never operate your miter saw on the floor or in a
crouched position. Failure to heed this warning can result
in serious personal injury.
The compound miter saw should be mounted to a firm
supporting surface such as a workbench, mounting board,
or miter saw stand. The saw base has four mounting holes.
If using bolts or screws, they should be of sufficient length
to accommodate the saw base, lock washers, hex nuts, and
the thickness of the workbench or other mounting surface.
Tighten all bolts or screws securely.
The hole pattern for mounting to a workbench is shown in
figure 7. Carefully check the workbench after mounting to
make sure that no movement can occur during use. If any
tipping, sliding, or walking is noted, secure the workbench
to the floor before operating.
LOCKING / UNLOCKING THE SAW ARM
See Figure 8.
To unlock and raise the saw arm:
 Firmly grasp the "D" handle and apply downward pressure
while at the same time pulling the lock pin out and away
from the saw housing.
 Release the lock pin and slowly raise the saw arm.
To lock the saw arm:
 Firmly grasp the "D" handle and apply downward pressure
while at the same time pushing the lock pin in and toward
the saw housing.
 Release the lock pin allowing it to lock the saw into place.
ASSEMBLY
INSTALLING THE REAR BRACKET/CARRYING
HANDLE
See Figure 9.
CAUTION:
A rear bracket is included with this miter saw to prevent
tipping if the saw arm is released suddenly. Do not use
this saw before installing the rear bracket/carrying handle
and securely mounting the saw to a work surface or stand
and may result in personal injury.
 Remove the screws from the rear bracket/carrying handle
and set aside.
 Slide the bracket in the openings on the saw base,
aligning the holes underneath the base with the holes in
the bracket.
 Insert the screws into the holes and tighten securely.
"D"
HANDLE
REAR BRACKET/
CARRYING HANDLE
14 - English
LOCK
PIN
Fig. 8
SCREWS
Fig. 9