Spindle Lock Button; Switch Trigger - Ryobi TS1143L Manuel D'utilisation

FEATURES
POSITIVE STOPS ON MITER TABLE
SWITCH SWITCH
Positive stops have been provided at 0°, 15°, 22-1/2°, 31.62°, LOCK TRIGGER
and 45° on both the left and right side of the miter table.
REAR BRACKET/CARRYING HANDLE
See Figure 2.
For convenience when carrying or transporting the miter
saw from one place to another, a carrying handle has been
provided at the rear of the saw. To transport, turn off and
unplug the saw, then lower the saw arm and lock it in the
down position. Lock saw arm by depressing the lock pin.
SELF-RETRACTING LOWER BLADE GUARD
SPINDLE
The lower blade guard is made of shock-resistant, see-
LOCK BUTTON
through plastic that provides protection from each side of
the blade. It retracts over the upper blade guard as the saw
is lowered into the workpiece.

SPINDLE LOCK BUTTON

See Figure 4.
The spindle lock button locks the spindle stopping the
blade from rotating. Depress and hold the lock button while
SWITCH
installing, changing, or removing blade.
TRIGGER

SWITCH TRIGGER

See Figures 4.
The saw will not start until you depress the switch lock with
your thumb then squeeze the switch trigger. To prevent
unauthorized use of the compound miter saw, disconnect it
from the power supply and lock the switch in the off position.
PADLOCK
To lock the switch, install a padlock (not included) through
the hole in the switch trigger and make certain the switch
is inoperable. If the switch is still operable with the padlock
installed, a padlock with a larger shackle diameter must be
used. Store the padlock key in another location.
Fig. 4
11 - English