Beurer TS 20 Mode D'emploi page 6

– Do not pierce the electric underblanket with needles or pointed objects.
– This electric underblanket must not be used by children unless the switch has been preset by their parents or
carers, or the child has been adequately instructed in how to use the electric underblanket.
– The electric underblanket must be checked frequently for signs of wear or damage. If any such signs are found or
if the blanket has been improperly used, it must be sent in to the manufacturer or dealer before it is used again.
– Repairs must be carried out only by skilled persons or a repairer authorized by the manufacturer, as special
tools are required. Improper repairs can result in considerable danger to users.
– If you have any further questions concerning the use of our products, please contact our customer service or
visit our website www.beurer.de/FAQ.81.0.html
2. Use
This electric underblanket is intended for warming beds. The electric underblanket heats up best when it is
switched on when covered with a quilt. The heating up time with the electric underblanket covered is
approx. 30 minutes. You can use either side of the electric underblanket.
The electric underblanket is fitted with the BEURER SAFETY SYSTEM (BSS). This electronic sensor technology prevents
the blanket from overheating over its entire surface by switching it off automatically in the event of a fault. If, as
a result of a fault, the electric underblanket is switched off automatically by the Beurer Safety System (BSS), the
signal lamp will no longer light up even when the blanket is switched on. Please note that for safety reasons the
electric underblanket must no longer be operated after a fault and must be sent in to the service address stated.
2.1 Operation
Place the electric underblanket on your mattress and spread it out flat starting from the foot end. Then as usual
place the quilt over it, so that the electric underblanket is between mattress and quilt. Always ensure that the
electric underblanket is spread out flat and is not folded or creased when in use. When making the bed, check its
position – the electric underblanket must be switched on only when it is spread out flat. We urgently recommend
that you switch on the electric underblanket for approx. 30 minutes before going to bed and covering it with
a quilt to prevent the heat from escaping. The electric underblanket with removable switch must be operated
only with the types of switch specified on the blanket.
Attention: The electronic components in the switch will cause the switch to warm up slightly when the
electric underblanket is being used. For this reason, the switch must never lie on the electric underblanket
or be covered by blankets, pillows etc.
2.2 Temperature selection
You will obtain the most rapid heating-up of the electric underblanket by first setting the highest temperature
level. For use over several hours, we recommend that you select the lowest temperature level.
2.3 Temperature levels
TS 20, 23
0 = off
1 = minimum heat
2 = medium heat
3 = maximum heat
3. Cleaning and care
Always remove the power plug from the power supply before cleaning the electric underblanket. Small spots can
be removed with a cloth or damp sponge and if necessary a little mild liquid detergent. Note that the electric
underblanket must not be dry cleaned, wrung out, machine dried or ironed. On no account switch on the electric
underblanket to dry it. Do not hang up the electric underblanket with clothes pegs or similar to dry it.