Figure 3.17: Diagnostics Dialog Box; Table 3.5: Diagnostic Test Details - Avocent AUTOVIEW 2020 Guide D'installation Et D'utilisation

34 AutoView 2020/2030 Installer/User Guide
3. Select the Run Diagnostics option. A warning screen opens, indicating that connected users will
be disconnected.
4. Click OK to begin.
The Diagnostics dialog box displays. Hardware tests are shown in the top of the dialog box ,while
the bottom portion divides the tested AVRIQ and IAC modules into three categories: On-line,
Offline or Suspect. See Figure 3.13.
NOTE: AVRIQ modules may appear to be offline while being upgraded.

Figure 3.17: Diagnostics Dialog Box

Next to each item to be tested, you will see a pass (green circle) or fail (red x) symbol display to the
left of each item as that test finishes. The following table details each of the tests.

Table 3.5: Diagnostic Test Details

Test
Firmware CRCs
On-line AVRIQ modules
Offline AVRIQ modules
Suspect AVRIQ modules
To run diagnostic tests:
1. If the OSCAR interface is not open, press
2. Click Commands
be disconnected.
Description
Reports on the condition of the main board RAM
Indicates the total number of currently connected and powered AVRIQ modules
Indicates the number of AVRIQ modules that have been connected successfully
in the past and are powered down
Indicates the number of AVRIQ modules that have been detected, but are either
unavailable for connection or have dropped packets during the ping tests
Run Diagnostics. A warning message displays indicating that all users will
-
Print Screen . The Main dialog box will appear.