Figure 3.6: Devices Dialog Box; Figure 3.7: Device Modify Dialog Box - Avocent AUTOVIEW 2020 Guide D'installation Et D'utilisation

22 AutoView 2020/2030 Installer/User Guide
2. Click Setup - Devices. The Devices dialog box displays.

Figure 3.6: Devices Dialog Box

When the AutoView switch discovers a cascaded switch, you will notice the port numbering
change to accommodate each server under that switch. For example, if the switch is connected to
ARI port 6, the switch port would be listed as 06 and each server under it would be numbered
sequentially 06-01, 06-02 and so on.
To assign a device type:
1. Press Print Screen
2. Click Setup. The Setup dialog box displays.
3. Click Devices. The Devices dialog box displays.
4. Select the desired port number.
5. Click Modify. The Device Modify dialog box displays.

Figure 3.7: Device Modify Dialog Box

6. Choose or enter the number of ports supported by your cascaded switch and click OK.
7. Repeat steps 3 to 5 for each port requiring a device type to be assigned.
8. Click OK in the Devices dialog box to save settings.
to launch the OSCAR interface. The Main dialog box displays.