Important Notices - Kolpin 2783 Instructions D'installation

Over-tightening any and/or all screws will cause cracks around mounting holes which is not covered by any
b)
Partially remove the protective film on both sides and install the lower windshield (Item B) to lower clamps using supplied hardware
(Item E) without applying final torque. Do not tighten at this stage; you will need to make adjustments later on.
c)
Partially remove the protective film on both sides and install
the upper windshield (Item A) to upper clamps and lower
windshield using supplied hardware (Item E) without applying
final torque. Adjust the position of the windshield and tighten
all screws with specified torque indicated below. Over
tightening clamps to roll bar could cause parts failures.
Domed shoulder
washer M6
Plastic shoulder
washer M6
Locknut
M6
2783 - Instructions YAMAHA YXZ Rear Windshield GP- rev00

IMPORTANT NOTICES

Torque specifications must be followed when tightening bolts.
Rear upper
windshield
warranty.
Domed shoulder
washer M6
Internal lock
washer M6
Button head screw
M6 x 18
Internal lock
washer M6
Domed shoulder
Button head screw
Rear lower
windshield
Button head
screw M6 x 18
washer M6
Internal lock
washer M6
M6 x 18
www.kolpin.com
IMPORTANT:
Torque
specification
Max. 5 foot-pounds
Applicable to all
Clamp screws
M6 x 20
(If torque tools are not
available, stop tightening
as soon as both male and
female clamp parts touch
as per picture below.)
2