Important Notices; Maintenance And Care - Kolpin 2763 Instructions D'installation

Over-tightening any and/or all screws will cause cracks around mounting holes which is not covered by any
c) Install the windshield to clamps using supplied hardware (Item F) without applying final torque. Adjust the position of the windshield
and tighten all screws with specified torque indicated below. Over-tightening clamps to roll bar could cause parts failures.
Button head screw
M6 x 18

2. Maintenance and Care

Tighten all hardware after first use and periodically thereafter.
 Rinse with lukewarm water; wash gently with mild soap or detergent and lukewarm water, using a soft cloth or sponge. DO NOT SCRUB
 To remove wet paint, glazing compound or grease, rub lightly with a good grade of VM&P naphtha or isopropyl alcohol, then wash and
NOTICE: Abusive cleaning procedures by hand washing or automated washing equipment will eventually result in visual hazing, loss of
Recommended products: Johnson Paste Wax, Novus Plastic Polish #1 and #2, Mirror Glaze plastic polish and Plexux1.
Testing polish on a separate Lexan sample is recommended. Be sure to follow product instructions carefully.
2763 - Instructions HONDA PIONEER 500 Rear Windshield Combo GP - rev00

IMPORTANT NOTICES

Torque specifications must be followed when tightening bolts.
Domed shoulder
washer M6
Internal lock
washer M6
 Rinse again. Dry with soft cloth or moist cellulose sponge to prevent water spotting.
light transmission and coating delamination.

Aqueous Solution of Soaps and Detergents
Joy Freon T.F. Palmolive liquid
MINIMIZING HAIRLINE SCRATCHES
For minimizing scratches and minor abrasions, mild automobile polish can be used.
warranty.
Button head screw
M6 x 18
CLEANING:
or use brushes or squeegees.
rinse. DO NOT USE GASOLINE.
Compatible Cleaning Agents
Top Job
Domed shoulder
washer M6
Internal lock
washer M6
VM&P grade Naphtha Windex
(with ammonia D)
www.kolpin.com
Button head screw
M6 x 18
Internal lock
washer M6
Domed shoulder
washer M6
IMPORTANT:
Torque
specification
Max. 5 foot-pounds
Applicable to all
Clamp screws
M6 x 20
(If torque tools are not
available, stop tightening
as soon as both male and
female clamp parts touch
as per picture beside.)
3