Kolpin 2707 Instructions D'installation

READ AND UNDERSTAND THESE INSTRUCTIONS COMPLETELY BEFORE INSTALLATION TO AVOID INJURY TO YOURSELF,
AS SPECIFIED ON CARTON LABEL, ONCE PROTECTIVE FILM ON SHIELDS IS REMOVED, PRODUCT CANNOT BE RETURNED.
AS SPECIFIED ON CARTON LABEL, DAMAGE CAUSED BY PACKAGING STAPLES IS NOT COVERED BY WARRANTY. ALL STAPLES MUST BE REMOVED PRIOR TO
FAILURE TO FOLLOW THESE INSTALLATION INSTRUCTIONS COMPLETELY MAY VOID ANY WARRANTABLE COMPONENTS AND RESULT IN PRODUCT DAMAGE
DO NOT USE LOCKTITE OR ANY OTHER SIMILAR FASTENER ADHESIVE. THESE TYPES OF PRODUCTS REACT TO PLASTICS AND CAUSE CRACKING. NOT
OUR WINDSHIELDS ARE MADE FROM THE HIGHEST QUALITY MATERIAL PROVIDING OPTIMUM TRANSPARENCY AND CLARITY. BLURRINESS AND/OR
EXTRUSION MARKS MAY OR MAY NOT APPEAR WHEN LOOKING THROUGH WINDSHIELD FROM A WIDE, SIDE-ANGLE. THIS IS NORMAL FOR ALL EXTRUDED
THE APPLICATION OF IMPROPER CLEANERS, ABRASIVE AND/OR DIRTY CLEANING TOWELS CAN SEVERELY DAMAGE THE PRODUCT. FAILURE TO FOLLOW
CLEANING RECOMMENDATIONS (PROVIDED HEREWITH) MAY VOID ANY WARRANTABLE COMPONENTS.
These instructions contain important information for future reference and must be given to the customer at time of purchase or upon completion
ITEM
A
B
INSTRUCTION BAG C
1. Installation
a) To apply the co-extruded bulb seal (Item B) to the windshield (Item A), find a clean flat area where you can lay down the windshield.
Partially remove the protective film on both sides and apply the co-extruded bulb seal using manual pressure to ensure good adhesion.
(the seal has an internal steel wire structure, a wire cutter is required)
2707 - Instructions CANAM COMMANDER Short Fixed Windshield GP - rev00
IMPORTANT NOTICES
DAMAGE TO THE VEHICLE OR ACCESSORY.
FOR PROPER INSTALLATION, TWO PEOPLE ARE REQUIRED.
TORQUE SPECIFICATIONS MUST BE FOLLOWED WHEN TIGHTENING BOLTS.
REMOVING PRODUCT FROM CARTON.
Parts List
(parts available with kit only and not available separately)
PART NAME
Windshield
Co-extruded bulb seal (¼")
Windshield Hardware
INSTALLATION INSTRUCTIONS
CANAM COMMANDER
SHORT FIXED WINDSHIELD
PART # 2707
OR PERSONAL INJURY.
COVERED BY WARRANTY.
CLEAR PLASTIC MATERIALS.
DEALER
of installation.
CNC windshield cut-out made of 3/16" thick GE (Lexan) polycarbonate or equivalent
Includes : 51" Co-extruded bulb seal [end user to cut to exact length]
Includes : 4 clamps 2" (loop type), 4 philips truss head screws ¼"-20 x 1", 4 plastic
shoulder washers ¼", 4 rubber washers ¼" and 4 nylon locknut ¼"
Co-extruded bulb
seal (+/- 49 ¾")
DESCRIPTION
WWW.KOLPIN.COM
QTY
1
1
1
1