Kolpin 2707 Instructions D'installation page 2

b) Install the windshield to the vehicle using supplied hardware (Item C). Adjust the position of the windshield and tighten.
Caution: over tightening any hardware could cause irreversible damage to the windshield.
Explode view
Clamp 2"
(loop type)
Clamp 2"
Detailed view of clamp
Phillips
(loop type)
truss head
screws
Nylon
Shoulder
¼"-20 x 1"
locknut ¼"
washers Rubber
¼"
washers
Rubber
¼"
washer ¼"
Nylon
locknuts ¼"
Windshield
Shoulder
washer ¼"
FRONT
Clamp 2"
(loop type)
Phillips truss head screw
¼"-20 x 1"
2. Maintenance and Car
Tighten all hardware after first use and periodically thereafter.
CLEANING:
 Rinse with lukewarm water; wash gently with mild soap or detergent and lukewarm water, using a soft cloth or sponge. DO NOT SCRUB
or use brushes or squeegees.
 Rinse again. Dry with soft cloth or moist cellulose sponge to prevent water spotting.
 To remove wet paint, glazing compound or grease, rub lightly with a good grade of VM&P naphtha or isopropyl alcohol, then wash and
rinse. DO NOT USE GASOLINE.
NOTICE: Abusive cleaning procedures by hand washing or automated washing equipment will eventually result in visual hazing, loss of
light transmission and coating delamination.
Compatible Cleaning Agents

Aqueous Solution of Soaps and Detergents
Joy Freon T.F. Palmolive liquid Top Job VM&P grade Naphtha Windex
(with ammonia D)
MINIMIZING HAIRLINE SCRATCHES
For minimizing scratches and minor abrasions, mild automobile polish can be used.
Recommended products: Johnson Paste Wax, Novus Plastic Polish #1 and #2, Mirror Glaze plastic polish and Plexux1.
Testing polish on a separate Lexan sample is recommended. Be sure to follow product instructions carefully.
2707 - Instructions CANAM COMMANDER Short Fixed Windshield GP - rev00 WWW.KOLPIN.COM
2