Important - Kolpin 1460 Instructions D'installation

d) To attach pivot components to upper windshield (Item A), as per step a), find a clean flat area where you can lay down the windshield.
Partially remove the protective film where components (Item G & H) are to be attached and follow drawings below. All screws that
are passing through the windshield will be tightened later in step f). Do not over-tighten the screws that combine the slide
arm with the lower pivot, those 2 parts need to swivel.
Button head
Shoulder
screw M6 x 18
washer M6
Internal lock
washer M6
Button head
screw M6 x 18
Do not over-tighten the
screws that combine the slide
arms with the lower pivots,
those parts need to swivel.
e) Install upper pivot cylinder adaptor to upper clamp as per drawings. Tighten all socket cap screws M6 x 45 (Do not tighten the
screw that holds the clamp to the roll cage. They will be tightened at next step).
1460 - Installation instructions for Kawasaki Teryx 2010 full tilt windshield revision 01
Lower windshield
(step a))
Button head
screw M6 x 18
Top pivot
Shoulder
washer M6
Lower pivot
Slide arm
Button head
screw M6 x 45
cylinder adaptor
Internal lock
washer M6
Locknut M6
Internal lock
washer M6
Button head
screw M6 x 18
Top pivot
WWW.KOLPIN.COM

IMPORTANT :

Torque
specification
Max. 5 foot-pounds
Applicable to all
Clamp screws M6 x
(If torque tools are not
available, stop tightening
as soon as both male and
female clamp parts touch
as per picture below.)
Shoulder
washer M6
20
2