c) Attach clamps (Item E) to the roll cage of your vehicle as per drawings. Do not tighten at this stage; you will need to make
adjustments later on.
d) Install windshield to clamps using M6 x 16 knobs as shown. Adjust height position and level of the windshield to ensure good fit with
hood. Tighten knobs and clamps only with specified torque indicated below.
2900A - Instructions JOHN DEERE XUV620i/850D/HPX Full Windshield With Access - revision 00
Female
clamp part
Locknut
M6
Female
clamp part
Knob
M6 x 16
If torque tools are not available,
stop tightening as soon as both
Male clamp
part
Male clamp
part
IMPORTANT :
Torque specification
Max. 5 foot-pounds
Applicable to all
Clamp screws M6 x 20
male and female clamp parts
touch as per picture beside.
WWW.KOLPIN.COM
Socket cap
screw
M6 x 20
2