Battery Removal - Remington Beard Boss Professional MB4132 Mode D'emploi

ENGLISH
CARING FOR YOUR TRIMMER
• To ensure long lasting performance of the trimmer, clean the blades and unit regularly.
• Ensure the appliance is switched off and unplugged from the mains.
• Do not use harsh or abrasive cleaners on the unit or blades.
• This product has washable blades. Ensure the blades are detached from the trimmer
before washing the blades.
• Wash the blades under a running tap to remove any hair clippings.
• After rinsing under a tap ensure the blades are dry.
• Do not rinse while the product is connected to the mains.
• Please note the main body of the trimmer is not washable and should be kept away
from water.
• After each use, it is recommended to clean hair from the blades either by rinsing the
blades or using a cleaning brush.

BATTERY REMOVAL

The appliance must be disconnected from the supply mains when removing the battery.
1. Turn the trimmer on and discharge all remaining power.
2. Remove the comb.
3. Detach the blade cartridge.
4. Remove the blade clip using a screwdriver.
5. Pry the two halves of the housing apart from one another to expose the inside.
6. Unscrew the two screws located toward the head end of motor bracket assembly and
one screw at the mid point of the bracket assembly.
7. Take out the bracket assembly from the housing.
8. Disconnect the battery from the circuit board.
• Used batteries must be removed from the appliance and disposed of at an appropriate
official recycling/collection point.
RECYCLING
W
6
To avoid environmental and health problems due to hazardous
substances, appliances and rechargeable and non-rechargeable
batteries marked with one of these symbols must not be disposed of
with unsorted municipal waste. Always dispose of electrical and
electronic products and, where applicable, rechargeable and
non-rechargeable batteries, at an appropriate official recycling/
collection point.