Table des Matières
Publicité
ENGLISH
BATTERY REMOVAL
We strongly recommend that a professional removes the rechargeable battery. Parts of
the shaver case, and tools have sharp edges and may cause injury if not handled correctly.
•
The rechargeable battery must be removed from the appliance before it is scrapped.
•
Disconnect the charging adapter before removing the battery.
1.
Ensure the device is discharged of all power. To do this, switch it on and allow it to run
until it stops.
2.
Remove the T-blade.
3.
Pry and remove the top decorative panel and top housing.
4.
Unscrew the 4 screws on the inner housing, and take off the top inner housing.
5.
Take out the assembly of battery and printed circuit board.
6.
Disconnect he battery from the circuit board.
•
Used batteries must be removed from the appliance and disposed of at an appropriate
official recycling/collection point.
RECYCLING
W
ADAPTER SPECIFICATIONS
Manufacturer address and
registration number
Adapter model number
Input voltage
Input AC Frequency
Output voltage
Output current
Output power
Average active efficiency
Efficiency at 10%
No load power consumption
8
To avoid environmental and health problems due to hazardous
substances, appliances and rechargeable and non-rechargeable
batteries marked with one of these symbols must not be disposed of
with unsorted municipal waste. Always dispose of electrical and
electronic products and, where applicable, rechargeable and
non-rechargeable batteries, at an appropriate official recycling/
collection point.
Spectrum Brands (UK) Limited, Regent Mill, Fir Street,
Failsworth, Manchester M35 0HS
Company number: 02394603
PA-0510U
100 - 240 V~
50/60Hz
5.0 V
D
1.0 A
5.0 W
≥73.7%
-
≤0.1W
Publicité
Table des Matières
