Table des Matières
Publicité
ENGLISH
C CLEANING AND MAINTENANCE
•
To ensure long lasting performance clean after each use.
•
Ensure the appliance is switched off and unplugged from the mains.
•
The easiest and most hygienic way to clean the appliance is by rinsing the
appliance head under the tap after use while the blades are running.
•
Allow water to run into and through the wash out port to help wash any
hair trimmings from the inside out.
, Note: Suitable for cleaning under water.
BATTERY REMOVAL
•
The battery must be removed from the appliance before it is scrapped.
•
The appliance must be disconnected from the supply mains when removing
the battery.
•
Ensure the trimmer is discharged of all power.
•
Firstly, pry the TST (detail blade) head housing using a single-side screwdriver.
•
Using a small screwdriver, unscrew 2 screws on the back housing of the
trimmer.
•
Continuously pry the front housing using the single-side screwdriver.
•
Pry the PCB holder assembly again using the single-side screwdriver from the
back housing so you can see the PCB and batteries exposed.
•
Destroy the PCB holder using a wire cutter, cut the tabs on both ends of the
battery assembly and remove the PCB.
•
Dispose of the batteries safely.
H ENVIRONMENTAL PROTECTION
To avoid environmental and health problems due to hazardous
substances in electrical and electronic goods, appliances marked with this
symbol must not be disposed of with unsorted municipal waste, but
recovered, reused or recycled.
6
Publicité
Table des Matières
