Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
GB
IE
Operational start-up
• Check that the pump is standing
firmly on the bottom of the shaft
or hung up safely.
• Check whether the pressure line
has been attached correctly and
the unused pump outlet is fully
closed.
• Avoid that the pump runs dry.
Regularly check the function
of the float switch. In case of
non-observance or if the pump
runs dry, guarantee and liability
claims are invalidated.
• Check that the electrical connec-
tion is 230 V ~50 Hz
• Check the proper status of the
electrical plug socket and make
sure that the plug socket is suf-
ficiently fused (at least 6 A, RCD
switch). Insert the pump plug into
the plug socket and the pump is
ready for operation.
• Make sure that moisture or water
never come in contact with the
mains connection. There is a risk
of electrocution.
Cleaning/Maintenance/
Storage
Clean and maintain your equipment regu-
larly. This will guarantee its performance
and long durability.
Ask our service centre to carry out
any work that is not described in
these instructions. Use only original
parts.
This will prevent damage to the
equipment and any resulting per-
sonal injury.
10
Pull out the power plug before
every maintenance operation. There
is a risk of electrocution or of injury
from moving parts.
General cleaning instructions
•
In case of transport for utilization in
different locations, the pump must be
cleaned with clear water after every
use.
•
In case of stationary installation, the
function of the float switch (
to be checked regularly (at the latest
every three months).
•
With a water jet, remove fluff and
fibrous particles which are possibly
present in the pump casing
•
Regularly remove sludge from the pit
base (at the latest every 3 months) and
also clean the shaft walls
•
Clean precipitation from the float
switch with clear water,
•
In the case of a long period of non-use,
the pump must be thoroughly cleaned
after the last use and before the new
use, since difficulties in start-up can
arise due to precipitation and residues.
Cleaning the Fan Wheel
In case of soiling or blockage of the impel-
ler, this can be cleaned via the pump outlet
(3) or by removing the floor plate (4):
1. Unscrew the bracket adapter
(
10) from the pump outlet
(
3).
2. Remove the 3 screws on the bot-
tom of the base (5) and take off
the base plate (4).
3. Clean the fan wheel using clean
water.
4. To re-assemble, reverse this order.
7) is
Publicité
Chapitres
Table des Matières
Dépannage
