Initial Operation; Mount Carrying Handle; Setting Up; Mains Connection - FLORABEST FGPS 1100 B2 Mode D'emploi

GB
device (residual current circuit breaker)
with a rated current of not more than
30 mA; minimum fuse 10 amperes.
• Before each use, check the equipment,
cable and plug for damage. Defective
cables are not to be repaired, but rath-
er replaced by new ones. Have any
damage to your equipment repaired
by a specialist.
• If the power cable for this equipment is
damaged, it must be replaced by the
manufacturer, a customer service agent
of the same or a similarly qualified per-
son in order to prevent hazards.
• Do not pull the plug from the socket by
the cable. Protect the cable from heat,
oil and sharp edges.
• Do not carry or fix the equipment by
the cable.
• Use only extension cables that are pro-
tected from spray water and designed
for outdoor use. Always fully unroll a
cable drum before use. Check the ca-
ble for damage.
• Before any work on the equipment,
during work breaks and in the case
of non-use, remove the plug from the
socket.
• The cross-section of mains connection
lines must be no smaller than rub-
ber hose lines with the designation
H07RN-F. The power cable wire cross
section must be at least 2.5 mm

Initial Operation

Mount carrying handle

Fix the carrying handle (7) to the
garden pump using the fixing
screws (8).
8
IB_270726_FGPS1100B2_CB3_FI_SE_BE_ts.indb 8

Setting up

• Place the unit on a firm, horizontal,
non-flooding surface.
• If you would like to install the device,
screw it together with the base. A
screw connection with a fastening
plate also prevents the device from slip-
ping.
By doing so, ensure a free access to
the drain screw (
• Always put up the garden pump at a
point higher than the water surface
you wish to pump water from.
Where this is impossible, install a low
pressure-resistant shut-off implement
between the appliance and the suction
hose (available from specialist retail-
ers).

Mains Connection

The pump you have purchases is already
fitted with an earthed plug. The pump is in-
tended for connection to an earthed socket
at 230 V ~ 50 Hz.

Connecting the hoses

- On the suction side, attach a
hose with reflow stopper and
install a prefilter (available from
specialist retailers).
2
- On the suction side, do not use
any quick-action connection sys-
tems.
- Do not use the suction hose as a
pressure pipeline.
1. Remove the cover caps (1/3)
from the device.
2. Attach the prefilter with reflow
stopper (15) to the connector
prefilter (16) at the suction hose
10).
30.09.15 10:39