Initial Operation; Assembly; Mains Connection; Setting Up - FLORABEST FGPS 1100 B2 Traduction Du Mode D'emploi D'origine

GB IE

Initial Operation

Assembly

C
• Fix the carrying handle (
garden pump using the fixing screws
C
( 8).

Mains Connection

The pump you have purchases is already
fitted with an earthed plug. The pump is in-
tended for connection to an earthed socket
at 230 V ~ 50 Hz.

Setting up

• Place the unit on a firm, horizontal,
non-flooding surface.
• To permanently install the garden
pump, screw it to the ground. Screw-
ing it to a fixing panel will prevent the
appliance from moving.
• Always put up the garden pump at a
point higher than the water surface
you wish to pump water from.
Where this is impossible, install a low
pressure-resistant shut-off implement
between the appliance and the suction
hose (Available from specialist retail-
ers).
• Connect the power cable (6) to the
power supply.

Connecting the hoses

On the suction side, attach a hose
with reflow stopper and install a
prefilter (Available from specialist
retailers). On the suction side, do
not use any quick-action connection
systems.
D
8
• Attach the prefilter with reflow stopper
•
C
7) to the
E
•
•
•
•

Filling the pump

Fill up the garden pump every time before
you start using it. This will ensure an im-
mediate start. Running dry will destroy the
pump.
• Open the filling screw (
• Fill with water to the fill point such that

Operational start-up

(15) to the connector prefilter (16) at the
pressure hose (13). Both piecese mar-
ked with a .
B
Remove the protective cap (
the garden pump water inlet (2).
Attach the Adapter (11) to the water inlet
(2) . Both pieces marked with an
Attach the connector water inlet (14) with
the seal ring (12) to the adaptor (11).
Both pieces marked with an
water inlet free from air.
Remove the protective cap (
the garden pump water outlet (4).
Fit a pressure hose to the water inlet (2)
Fit the water inlet free from air.
Air in the suction hose will stop the
garden pump from working prop-
erly.
garden pump.
water starts to run out of the filling
A
screw ( 9) hole. Retighten the filling
screw ( A 9).
• Check that the electrical connec-
tion is 230V ~50Hz
B
1) from
.
A
. Fit the
A
B
3) from
A
9) on the