Remote Control And Keyless Entry; Homelink - Chamberlain B4603TC Manuel D'installation

Operation

Remote Control and Keyless Entry

PRE-PROGRAMMED REMOTE CONTROL INCLUDED, NO NEED TO PROGRAM THE
REMOTE.
To add or reprogram a remote control, follow the instructions below. Older Chamberlain remote controls are
NOT compatible.
PROGRAM MOTION DETECTING CONTROL PANEL
Press the LEARN button on the door control to enter programming mode. The command LED will flash
1.
once.
Press the LEARN button again, the command LED will flash once again.
2.
Remote control: Press the button on the remote control that you wish to operate your garage door.
3.
Keyless entry: Enter a 4-digit personal identification number (PIN) of your choice on the keyless entry
keypad. Then press the ENTER button.
The garage door opener lights will flash (or two clicks will be heard) when the code has been programmed.
Repeat the steps for programming additional remote controls or keyless entry devices. If programming is
unsuccessful, repeat the steps using the LEARN button on the garage door opener.
1-2
3
OR
? ? ? ?
PIN
PROGRAM USING THE GARAGE DOOR OPENER LEARN BUTTON
Locate the LEARN Button.
1.
Press and immediately release the LEARN button. The LEARN LED will glow steady for 30 seconds. Within
2.
30 seconds...
Remote Control: Press and hold the button on the remote control that you wish to use.
3.
Keyless Entry: Enter a 4-digit personal identification number (PIN) of your choice on the keyless entry
keypad. Then press and hold the ENTER button.
Release the button when the garage door opener lights blink or two clicks are heard.
1-2
3
OR
HomeLink®
If your vehicle is equipped with HomeLink®, a Compatibility Bridge™ (not included) may be necessary for
certain vehicles. Visit bridge.chamberlain.com to find out if a Bridge is needed.
38
LEARN
Button
LEARN LED
PIN