Information Regarding Machine Demolition - Corghi BR-AP Manuel D'utilisation

WARNING
Any procedure aimed at changing the pressure setting on the pressure relief device
is strictly prohibited.
The manufacturer declines any and all responsibility for damage caused by tampering
with these regulators.
WARNING
Before proceeding with any adjustment or maintenance work, disconnect the machine
from pneumatic and electric power supply, and check that all the moving parts are
locked in place.
ATTENTION
Do not remove or make changes to any part of this machine (only the assistance serv-
ice may do this).
- The regulator/lubricator filter is equipped with a semi-automatic condensate water drain.
This device is automatically activated whenever pneumatic supply to the machine is
cut off. Drain manually when the level of condensate is too high.
- From time to time, lubricate the spindle carrier arm on the rotation axis.
- On a regular basis, when the machine is at a standstill, remove the back panels and
remove the yarn fluff that has collected there. Be careful not to pull out the electric
wires. Do not use compressed air to clean the machine, since this will spread the yarn
fluff on the mechanical moving parts and the electronic components.
WARNING
Keep the work area clean.
Do not clean the machine with compressed air, jets of water or thinner.
When cleaning the area, take steps to avoid raising dust as far as possible.
INFORMATION REGARDING MACHINE
If the machine is to be scrapped, remove all electrical, electronic, plastic and metal parts
and dispose of them separately in accordance with current provisions as prescribed by
law.
Operator's manual BR-AP/AP-S
DEMOLITION
UK
37