Cleaning The Machine; Checking/Cleaning/Exchanging Ventilation Filters; Checking Electrical Components; Final Tasks - Schwamborn DSM 650-RC Manuel D'utilisation

EN
DSM 650‐RC / DSM 800‐RC

5 Acceptance and transportation

1. Tilt the machine (! Chapter 4.2.1 ‐ page 27).
2. Gently tap with a lump hammer to loosen the
tools [50, Fig. O] from the tool
mount [51, Fig. O] and then remove.
3. Insert new tools into the recess [49, Fig. O] of
the tool mount and press firmly in the direction
of the arrow (use lump hammer in the direction
of the arrow if necessary).
4. Set the machine upright
(! Chapter 4.2.2 ‐ page 27).

4.5 Cleaning the machine

1. Tilt the machine (! Chapter 4.2.1 ‐ page 27).
2. Clean the machine and tools dry with a cloth or
suitable agents.
3. Set the machine upright
(! Chapter 4.2 ‐ page 27).

4.5.1 Checking/Cleaning/Exchanging ventilation filters

To safeguard cooling of the electrical components,
the 2 ventilation filters need to be cleaned if heavily
soiled.
1. Remove both covers [54, Fig. Q]
(8 screws each, ! arrows).
2. Open both filter lids [55, Fig. Q].
3. Check both filters [56, Fig. Q] and clean if heav­
ily soiled.
4. Close both filter lids.
5. Mount both covers (8 screws each).

4.6 Checking electrical components

Only suitably knowledgeable, qualified profes­
sional electricians may perform work on any
electrical parts of the machine!
Risk of fire due to faulty electrical cables! Check
the mains cable and power plug regularly for
functional safety!

4.7 Final tasks

Either shut down the machine:
a. Disconnect the power plug [37, Fig. E] from
the mains.
b. Disconnect the dust extraction [36, Fig. E]
from the machine.
c. If necessary, open the manual valve
[42, Fig. A] and empty the tank.
28
d. Swivel both weight elements to the
standard position A
(! Chapter 4.3 ‐ page 27).
e. Reduce the projection if necessary:
Adjust the guide bar forwards (over the
grinding unit [11, Fig. P]
(! Chapter 3.1.1 ‐ page 23).
Or restart the machine:
(! Chapter 3.1 ‐ page 22).
5 Acceptance and transportation
Observe the safety instructions in Chapter 2!

5.1 Machine acceptance

The machine is delivered in a complete and pack­
aged condition from the manufacturer.
1. Unpack the machine and check the enclosed
delivery slip to make sure all parts have been
delivered.
2. Check for any transportation damage.
In case of damage, contact the transport com­
pany promptly!
Report any problems to the manufacturer imme­
diately!
Complaints at a later date cannot be acknowl­
edged!

5.2 Transporting the machine

Risk of injury from heavy loads!
Suspended loads can fall or tip over, causing
serious injuries!
Do not stand under suspended loads!
Never reach beneath the load while it is being
lowered!
Lift the load only as high as necessary!
Prevent the load from swinging back and forth!
Keep sufficient safety distance!