Yakima BigStack Instructions De Montage page 6

INSTALL SKS LOCKS ACCORDING
TO LOCK INSTRUCTIONS
(Purchased separately).
BOW STERN TIE DOWN ATTACHMENT
Attach buckle strap to boat.
Attach strap to grab handle or
rescue bar and pull tight.
Failure to secure front and rear of long
loads to ends of vehicle can result in
property damage, personal injury, or death.
Slide plastic tube to protect vehicle
at contact point.
NOTE: Twisting the strap will
help reduce wind vibration.
Insert end of plain
strap into buckle.
HOOD ANCHORS:
Instruction #1033411D-6/21 Instruction #1033411D-6/21
adjustment knob
Attach hook to plain
strap loop.
Bow and stern tie-downs are required
when transporting boats. If your vehicle
does not have a tie-off point or the tie-
down would damage the vehicle, then
Hood Anchor (Yakima part # 8007416)
MUST be used. If these options do not
work, please contact Yakima directly to
discuss other usage options.
Lines on
and BigStack
base must be
aligned to lock.
Check straps periodically during travel and tighten
if necessary. Replace any straps that are worn or
frayed before using (see your Yakima dealer).
Adjust strap tension
by pulling plain end.
• Apply even
pressure to front
and rear straps.
• Bind up and tie off
any excess strap.
Hook the strap to a metal sur-
face on the bumper, tow loop,
or frame hole using hook.
Align