Yakima BigStack Instructions De Montage page 5

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

CONTINUE TO LOAD THE BOAT— TIE IT DOWN WITH STRAPS
TO LOAD STRAP WITH
BIGSTACK IN UPRIGHT
POSITION:
LOOP STRAP AROUND
BIGSTACK POST.
Cross lines and set
aside.
• Hook the strap at the
top of the BigStack.
• Slide buckle up so
that it hangs at top
edge of boat.
NOTE: Straps are to be inside of towers. If straps
are to be outside of tower due to tower/bar
position, use STRAP CAPS (Yakima part number
8005015) to prevent straps from sliding off the end
of the crossbars.
Yakima part number 8005015
(sold separately).
CONNECT
AND TIGHTEN
• Insert end of strap
into buckle as
shown.
Instruction #1033411D-5/21
LOAD BOAT.
• Bring straps up and over boat.
• Hang to the side.
ADDED SECURITY:
• Pass strap inboard under
crossbar.
• Pass strap under boat
around base of BigStack.
• Pass under crossbar again
and attach to buckle.
TIGHTEN STRAPS:
• To tighten straps,
hold and pull.
• Secure extra strap.
Strap outside
of tower.
Use Strap Cap.

Publicité

Table des Matières
loading

Table des Matières