Assembly - L.B. White Tradesman CP075EK Guide De L'utilisateur Et Instructions D'installation

TOOLS REQUIRED
CP075EK
- Medium Phillips screwdriver.
1.
on the upper housing.
2. Remove the pre-assembled screws on the shell upper and side cover.
3. Align the holes in upper housing with two mounting holes on the handle as shown in Figure 4.
4. Secure handle with screws removed.
5. Insert cord wrap into the rectangle holes on the supporter and align the hole on the cord wrap with
the mounting hole on the side covers shown in Figure 4.
6. Secure cord wrap with screws removed.
CP125FK/CP175FK/CP210FK
- Medium Phillips screwdriver.
- M5 open, or adjustable wrench.
1. Slide threaded axle through the rear section of the wheel support frame.
2. Slide one axle bushing on to each side of the axle. Slide one wheel on to each side of the axle.
3. Attach one cap nut on to each side of the threaded axle and tighten well.
4. Place heater on wheel support frame. Make sure the air inlet end (rear) of heater is over wheels. Align the holes on fuel
5.
6. Align the hole on the handle (front and rear) with the mounting hole on the cord wrap.
7.
8.
WARNING
Fire or explosion hazard!
- Do not operate heater without support
frame fully assembled to tank.
CP075EK Model
Handle
CP125FK/CP175FK/CP210FK Models
Wheels Cord Wraps
Installation and Assembly Instructions
Model
Wheel Support Frame
Wheels
Front-Handle
Rear-Handle
Axle
Cord Wrap
Hardware Kit
Handle
Cord Wraps
572281
Screws Flange Screws Nuts
Cap Nuts S Bushings Cap Nuts L
CP075EK
No
No
No
No
No
Yes
No
Yes
Handle
Remove Screws
Remove Screws
Figure 4 - Handle and Cord Wrap Installation CP075EK
Front
Handle

ASSEMBLY

CP125FK CP175FK
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
No No
Screw
Front Guard
Wedged Portion
Slit Hole
Upper Shell
Cord Wrap
Side Cover
Screw
Wheel Support Frame
Axle
CP210FK
Yes
Yes
Yes
Yes
Yes
Yes
Yes
No
Rear
Handle
8