Installing The Foil Sensor (Optional) - Sentiotec just sauna fin JUST-105D-FI Instructions De Montage Et Mode D'emploi

Installation instructions, only for experts
2. Pull the two half-shells of the bench sensor apart.
3. Connect the two connectors for the bench sensor wire to the two middle
terminals on the connection panel.
4. Place the connection panel crossways in the bench sensor half-shells.
5. Place the two half-shells together and screw them together using the two
Phillips-head screws (9 mm).
6. Check whether the bench sensor has been securely closed.
7. Install the bench sensor on the wall of the sauna room using the two wood
screws enclosed (16 mm). Maintain an interval of 15 cm to the roof of the
sauna room.

4.5. Installing the foil sensor (optional)

If one of the following infrared heat plates is connected to an additional output,
the foil sensor P-ISX-FF must be used:
● IR-WP-100
● IR-WP-175
● IR-WP-390
● IR-WP-510
● When installing the foil sensor, observe the operating instructions for the
infrared heat plates.
● The foil sensor must be activated when starting up the sauna for the fi rst time
(see 8.6. Activating/deactivating the foil sensor on page 29).
WORLD OF WELLNESS
● IR-WPHL-100
● IR-WPHL-175
● IR-WPHL-390
● IR-WPHL-510
p. 17/44
EN