Utility Hook - DeWalt DPN1850-XJ Traduction De La Notice D'instructions Originale

DPN1564A-XJ, DPN1664-XJ
These nailers are equipped with dual load purpose
magazines. Nails can be loaded in either method.
LOAD AND PULL PUSHER
1. Load nails through the slot in the rear of the magazine
and past retaining clip. (Fig. 7)
2. Pull pusher back behind nail stick and release. (Fig. 8)
3. Ensure magazine pusher is behind the last nail stick.
(Fig. 9)
PULL PUSHER TO LOCK BACK AND LOAD
1. Pull pusher back until it is locked at the end of
magazine. (Fig. 10)
2. Load nails through the slot in the rear of the magazine
and past retaining clip. (Fig. 11)
3. Press the pusher button to release and allow the pusher
to push behind the nails. (Fig. 12)
4. Blow the magazine clean periodically to keep the
pusher moving smoothly and to keep dirt and debris out
of the nail channel.
JAM CLEARANCE
m Warning! Always disconnect the air before clearing
a jammed fastener.
Jam Clearing
1. Disconnect the air supply from the tool.
2. Relieve fasteners from pusher or open the magazine.
3. Open the jam clearing nose door by pulling down and
then up on the latch (Fig. 13).
4. Remove the jammed fastener. In certain circumstances,
pliers may be required to remove the fastener.
5. Close the jam clearing nose door latch (Fig. 14).
6. Pull pusher back behind fasteners or close the
magazine.
FASTENER CONTROL ADJUSTMENT (Fig. 15)
The DIAL-A-DEPTH™ Fastener Control adjustment
feature provides close control of the fastener drive depth;
from flush with the work surface to shallow or deep
countersink.
First, set the air pressure for consistent drive in the
specific work, then use the DIAL-A-DEPTH™ Fastener
Control adjustment to give the desired depth of drive.
TRIGGER LOCKOUT CONTROL (Fig. 16)
(DPN1564A-XJ, DPN1664-XJ)
The trigger lockout control feature on D
tools provides a trigger lock feature for added safety
control. Push the Lockout control button in or out to
activate or lock the tool trigger.

UTILITY HOOK

These tools may include an additional utility hook suitable
for storage and temporary hanging of the tool.
m WARNING! Never use the utility hook to hang the tool
from the body, clothing or belt.
m WARNING! Never use the utility hook with contact
(black) trigger operated tools.
EN GL I SH
WALT pneumatic
E
7