Cable Connecting Your Mp3 Player Or Other External Audio Sources - SCHUBERTH SRC-System Guide D'utilisation

RDS ON/OFF (press simultaneously 3 seconds while Radio is on)
• FM Radio ON / OFF (press 3 sec.)
• Switch among pre-saved stations (tap briefly)
Searching for and setting new stations
1. while the Radio is on, press and hold the Volume Up or Volume
Down Button for three seconds or until you hear the next station
on your headset.
• Pressing Volume Up will search upwards (higher frequency).
• Pressing Volume Down will search downwards (lower
frequency).
2. Once a station is found, searching stops and you can hear the station.
3. To continue searching, press the Volume Up or Volume Down But-
ton again for three seconds.
4. To save this station, refer to the following section. You may still
continue to listen to the current unsaved station.
Saving a selected station
1. Select the station number from one to six that you wish to set by
tapping the CHANNEL "B" button until the desired station is found.
2. Search for a new station as described in the section above.
QG SRC 207 - MAN00015.indd 31
3. Tap the CHANNEL "B" button within 20 seconds of finding the sta-
tion to save the current station.
4. To save another station, tap the CHANNEL "B" button again to
reach next station number.
5. If you don't save the station, the Radio will exit search mode with-
out saving the current station. You can still continue to listen to the
current unsaved station. Tapping the CHANNEL "B" Button in this
case will move to the next saved station.
You can store up to six stations.
7.2 CABLE CONNECTING yOUR MP3 PLAyER OR OTHER
EXTERNAL AUDIO SOURCES
Using the auxiliary line-in port for cable connectivity
Your headset allows you to connect non-Bluetooth® audio sources,
such as MP3 players to the headset by using the enclosed cable.
1. Make sure the headset is on Standby mode, flashing slowly in Blue.
2. Connect the MP3 cable to your MP3 player/audio source's
headset jack and insert the other
end of the cable into the micro USB
Connector.
3. Operate the MP3 Player device by using its own buttons as usual
(FF / REw / PLAY / PAUSE).
Volume can be adjusted through the MP3 Player or the Volume
Buttons of the headset.
Any other audio connection will automatically mute the MP3 Player. The
audio signal will return only when headset is once again in Standby
mode.
NOTe: while listening to your MP3 player, the VOX feature is disabled
31
2/1/11 11:38 AM