Product Description - ABB i-bus Busch-Wachter Master 220 HGL EIB Mode D'emploi

Product Description

GB
This watchdog is a passive infrared motion detector:
If a heat source is detected somewhere in the zone of
coverage messages are sent via the bus line according to
the units parameter setting. This causes, for example, a
connected lighting system or a signaling unit to be switched
on via the bus line (according to the parameter setting of
the relevant EIB devices ).
When the heat source leaves the coverage zone or remains
stationary or immovable this is signaled as per the
parameter setting to the bus line after a preset cutout delay
(rundown time) has elapsed (eg an activated lighting
system may then be switched off).
An integrated dusk sensor enables the switching
brightness (ambient luminosity) to be set at which the unit's
monitoring function is activated.
The parameters governing the switching behavior can be
set using the ETS2 (see Technical Manual and individual
windows displayed by the parameterization software
package). Optionally, the operating modes, switching
brightness and cutout delay may also be set directly on
the unit.
>>>