Cutout Delay - ABB i-bus Busch-Wachter Master 220 HGL EIB Mode D'emploi

Cutout Delay

GB
This will rule out, for instance, that the illumination in a
staircase is operated and switched on and off constantly.
The cutout delay can be set to any
32
value ranging between 10 seconds
and 32 minutes.
Note: When a new movement is detected within the
coverage zone while the set timer runs down the adjusted
time period starts anew if the dusk sensor has given an
enabling signal at this time.
If the time period is short and a strong infrared signal
prevails (eg during sunlight) minor cutout delay deviations
may occur.