Refrigerator Use; Using The Controls; Ice Maker - IKEA W10679599A Instructions D'installation Et D'utilisation

2. Open both doors again to make sure they close as easily as
you like. If not, tilt the refrigerator slightly more to the rear by
turning both leveling legs to the left; it may take several more
turns.
NOTE: To keep the refrigerator level you should turn both
leveling legs the same amount.
3. Using a level, be sure that the refrigerator is still level side to
side. Readjust if necessary.

REFRIGERATOR USE

Using the Controls

Your refrigerator has two controls that affect the temperature. The
Temperature control is located at the top front of the refrigerator
compartment and the Air Flow control is located on the back wall
of the freezer compartment.
Temperature Control
The Temperature control regulates the coldness of the air flowing
into the compartments.
For your convenience, your refrigerator controls are preset at the
factory. When you first install your refrigerator, make sure that the
controls are still preset to the mid-setting as shown.
NOTE: To turn your refrigerator off, turn the refrigerator control to
the word OFF. Turning the Temperature Control to OFF stops
cooling in the refrigerator and freezer compartments, but it does
not disconnect the refrigerator from the power supply.
Mid-setting "3"
IMPORTANT:
Give your refrigerator time to cool down completely before
adding food. It is best to wait 24 hours before you put food
into the refrigerator.
NOTE: Adjusting the Temperature Control to a higher (colder)
setting will not cool the compartments any faster.
If you add food before the refrigerator has cooled completely,
your food may spoil.
Adjust the Temperature Control
The mid-settings should be correct for normal household usage.
The controls are set correctly when milk or juice is as cold as you
like and when ice cream is firm.
If the temperature is too warm or too cold in the refrigerator or
freezer, first check the air vents to be sure they are not blocked.
If you need to adjust temperatures, use the settings listed in the
chart below as a guide. On models with two controls, adjust the
refrigerator temperature first. Wait at least 24 hours between
adjustments and then recheck the temperatures.
CONDITION/REASON:
REFRIGERATOR section too warm
Door opened often, large
amount of food added or room
temperature very warm
FREEZER section too warm/ice not
made fast enough
Door opened often, or large
amount of food added or very
cold room temperature (can't
cycle often enough)
Heavy ice usage
REFRIGERATOR section too cold
Controls not set correctly for
your conditions
FREEZER section too cold
Controls not set correctly for
your conditions
Air Flow Control
The Air Flow control regulates the amount of air flowing between
the freezer and the refrigerator compartments.
When you plug in the refrigerator for the first time, turn the Air
Flow control to the Recommended setting.
Adjust the Air Flow Control
If you want to temporarily increase the cold air flow to a specific
compartment, adjust the control.
Max - Increase air flow to the freezer
Min - Increase air flow to the refrigerator
IMPORTANT: Once the performance is achieved, return the Air
Flow control to the Recommended setting to keep the refrigerator
operating at optimum efficiency.
CONDITION/REASON:
Heavy ice use
Hot room temperature
Large quantity of groceries

Ice Maker

(on some models - Accessory)
Turning the Ice Maker On/Off
NOTE: Do not force the wire shutoff arm up or down.
To turn the ice maker on, simply lower the wire shutoff arm.
NOTE: Your ice maker has an automatic shutoff. As ice is
made, the ice cubes will fill the ice storage bin and the ice
cubes will raise the wire shutoff arm to the OFF (arm up)
position.
ADJUSTMENT:
Adjust REFRIGERATOR
Control one setting
higher
Adjust AIR FLOW or
REFRIGERATOR Control
one setting higher
Adjust REFRIGERATOR
Control one setting
lower
Adjust AIR FLOW or
REFRIGERATOR Control
one setting lower
ADJUSTMENT:
Max
Max - To maintain ice making
production rate
Min - To quickly chill food and
beverages
9