Table des Matières
Publicité
Connector identification at the control unit:
1
31 / 30 / 15
2
3
Receiver
4
SAT OUT
antenna
5
SAT IN
6
AUX-Relais
1
Rear of the vehicle
2
Driving direction
3
Elbow connector
4
External unit
5
Assembly plate
6
Length 4.5 m from external unit
7
Operating device
8
Western cable length 6.5 m from
Operating device
9
fuse fixing
10
Control unit
Due to the safety regulation of ten Haaft required:
Zündung / Klemme 15
muss angeschlossen werden
!
Zum automatischen Einfahren der Antenne
bei Fahrzeugstart
Ignition switch has to be connected
For automatic retraction of the antenna
at vehicle start
Allumage doit être connecté
Pour rétracter automatiquement l'antenne
au démarrage du véhicule
Connect here the provided power cable.
ATTENTION!
Make sure beforehand that the power cable is correctly connected to electricity mains of the
vehicle at the other end; in case of wrong polarity the control unit can be destroyed!
Connect here the white 15 pin plug of the provided control cable to the external unit. (Control
cable and coax cable to the external unit are together in a black sheath.)
Connect here the provided Western cable (similar to a telephone line), and plug the other cable
end into the operating control device.
Connect this socket with the input socket of your satellite receiver using the included shorter
coax cable.
Connect here the antenna plug (F plug) of the provided control cable to the external unit.
(Control cable and coax cable to the external unit are together in a black sheath.)
optional switch contact für TV device
!
11
Coax cable Length 1.5 m from
control unit
12
Cable (black)
Receive (not comprised in scope of delivery)
13
24
Cable (brown - minus pole)
25
Cable (red - plus pole)
On-board battery
26
Ignition switch / clamp 15!
27
28
Publicité
Table des Matières
