diagral DM500 Mode D'emploi page 30

For example, to program the light function: after the 2 keys are pressed simultaneously
twice at the beginning, enter the sequence 1,0, 0 followed by 1, and end programming
with the simultaneous key presses.
To start programming
35
Press 0 and 1
simultaneously until
the programming
indicator light
goes out.
Important: if you wait more than 7 seconds between 2 key presses or if you do not
press 0 and 1 simultaneously, or for long enough, at the beginning and at the end of
the procedure, you will no longer be in programming mode. The indicator light will start
flashing because the programming is incorrect. The radio code initially programmed is
retained. Repeat the procedure from the beginning.
Testing the function selected
2
Hold down the test button (for 7 seconds) until the indicator light goes out. The number of
times the indicator light flashes confirms the function programmed.
For example: you have reprogrammed the detector to "light" mode, the indicator light will
flash 5 times.
If the number of flashes does not correspond with the information on the table below,
repeat the function programming procedure.
FIG. G
Installation
Select where to install the detector following the advice on installation.
1
Locate the fixing holes (about 2.20 metres above the ground) on the wall mount by tur-
2
ning the detector as far as it goes to the right and to the left on the adjustment axis
(without taking off the adjustment axis).
Screw the wall mount in place using the plugs and screws supplied in the accessory
3
pack, or others if they are more suitable. The 2 holes at the bottom of the base make it
easier to tighten the screws.
Close the detector to position it at the right angle. Tamper protection is active to protect
4
against any attempt to open the detector.
Keep the detector closed while tightening the securing screw.
5
35
Again press
4 sequential key presses
0 and 1
simultaneously until
the programming
indicator light
indicator light comes on
goes out.
(Fig.
Programming
1 0 0 1
▲
corresponding to the
function code to be
programmed The
with each key press.
F)
To finish programming
35
Press 0 and 1
simultaneously until the
indicator light goes out.
The indicator light will then
come on for 5 seconds to
indicate the programming
has been successful.
GB
30