diagral DM500 Mode D'emploi page 29

If the base unit does not respond as expected, recode the detector. If the problem persists,
recode the base unit and try again.
You have now transferred your personalised radio code to the detector.
Programming the functions
●
When you unwrap the detector it is pre-programmed to the function "advance alarm".
You can keep this programming or change it to another function according to the table
below.
Function
Zone 1
Zone 2
Zone 3
Zone 4
Light (1)
Audible call (1)
Advance alarm (2)
(1) Active round the clock, whatever the setting at the base unit. To avoid wasting the bat-
tery, if whatever prompts detection remains in place, the detector may become inactive for
several minutes. To return to normal functioning, you must leave the detection zone for at
least 90 seconds.
(2) Active only when Fully Set and Group B Set (When group B is set, the base unit only
will sound an alarm for 10 seconds).
Program the selected function (a sequence of 4 digits made up of "0" and "1") using
1
the keys on the detector.
To start programming
35
Press 0 and 1
simultaneously until
the programming
indicator light
goes out.
(Fig. E)
Code to program.
0 0
0 0
0 1
0 1
1 0
1 1
1 1
35
Again press
4 sequential key presses
0 and 1
simultaneously until
the programming
indicator light
indicator light comes on
goes out.
0 1
1 1
0 1
1 1
0 1
0 1
1 1
Programming
▲
corresponding to the
function code to be
programmed The
with each key press.
Function confirmation
indicator light flashes once
indicator light flashes twice
indicator light flashes 3 times
indicator light flashes 4 times
indicator light flashes 5 times
indicator light flashes 7 times
indicator light flashes 8 times
To finish programming
35
Press 0 and 1
simultaneously until the
indicator light goes out.
The indicator light will then
come on for 5 seconds to
indicate the programming
has been successful.
GB
29