Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Mark crosses on the 1st line of the grid below in the squares corresponding to the per-
1
sonalised radio code on your base unit coding template. (one cross for each hole).
Personalised radio code
Detector code
On the 2nd line write a "0" (zero) below each cross.
2
Fill in the empty squares on the 2nd line with "1" (one)
3
For example, (do not use this) you have pierced holes 2, 7 and 8 on your template.
Personalised radio code
Detector code
You will see a sequence of 10 digits made up of zeros and ones corresponding to the
code to program into your detector.
N.B. the code 0000000000 is not valid.
Program your radio code by keying in
4
below:
To start programming
35
Press 0 and 1
simultaneously until
the programming
indicator light
goes out.
Important: if you wait more than 7 seconds between 2 key presses or if you do not
press 0 and 1 simultaneously, or for long enough, at the beginning and at the end of
the procedure, you will no longer be in programming mode. The indicator light will start
flashing because the programming is incorrect. The radio code initially programmed is
retained. Repeat the procedure from the beginning.
Testing the personalised radio code
5
If you are adding to an existing system, you must first change the base unit to test
mode to carry out the test. Please refer to the alarm system installation guide.
Press the detector test key briefly test and check that the base unit (which has already
been coded) gives an audible message as well as the "Alarm" indicator light coming
on or speaks the voice message
1
2
1
2
X
1
0
0
Programming
▲
10 sequential key presses
corresponding to the radio code
to be programmed. The indicator
light comes on with each key press.
"ADVANCE
ALARM".
3
4
5
6
3
4
5
6
1
1
1
1
and
on your detector as indicated
1
Press 0 and 1 simultaneously until the
programming indicator light goes out.
The indicator light will then come on
for 5 seconds to indicate the
programming has been successful.
(Fig.
F)
GB
7
8
9
10
7
8
9
10
X
X
0
0
1
1
To finish programming
35
28
Publicité
Table des Matières
