Assembly Instructions - Christopeit Sport E 2000 Notice De Montage Et D'utilisation

ASSEMBLY INSTRUCTIONS

Remove all the separate parts from the packaging,
lay them on the floo and check roughly that all are
there on the base of the assembly steps. Please note
that a number of parts are connected directly to the
main frame preassembled. In addition, there are sev-
eral other individual parts that have been attached to
separate units. This will makes assembly easier and
quicker for you. Assembly time: 60 min.
STEP 1:
Attach the stabilizer (93+72) at main frame (19).
1. Attach the front foot (93) with preassembled
transportation roller (92) to the main frame (19). Do
this with the two screws M8x20 (11), washers (14)
and spring washers (12).
2. Attach the rear foot (72) with preassembled
height adjustable screw (99) to the main frame (19).
Do this with the two screws (11), washers (14) and
spring washers (12). After assembly has been com-
pleted, you can compensate for minor irregularities
in the foor by turning the foot screw (99). The equip-
ment should be set up that the equipment does not
move of its own accord during a training session.
STEP 2:
Connection of cables (2+18) and assembly of sup-
port (3) at the main frame (19).
1. Place screws M8x20 (11), washers and curved
washers (13+14) and spring washers (12) accessibly
beside the front part of the main frame (19).
2. Place the lower end of the support (3) against
the main frame (19) and push the plastic cover (16)
onto the support (3). Plug the ends of the two com-
puter cable harnesses (2+18) projecting from (3+19)
together. (Note: The computer cable harness (2) pro-
jecting from the support (3) must not slide into the
tube, as it is required for later steps of installation.)
When joining the tubes, ensure that the cable con-
nection will not trapped.
3. Put one spring washer (12) and one washer (14)
or curved washer (13) on each screw (11). Push the
screws (11) through the holes in the support (3),
screw into the threaded holes of the main frame (19)
and tighten frmly. Push the support cover (16) into
right position.
16
GB