Jotul F 370 Série Manuel D'installation Et D'utilisation page 13

Jøtul F 376 – Glass base
NB! If connecting the flex hose through a hole in the floor, do not
knock out the removable cover plates (Fig. 18 A).
Fig. 18
1. Loosen the screws holding the upper glass clips on either
side (Figs. 18 B and C). Check that the lever on the external
air vent is in the forward position (Fig. 4D).
2. If connecting a flex hose (Ø 100 mm) for external air supply
to the external air vent/outlet (Fig. 4 C) beneath the burn
chamber, first drill a hole (Fig. 18 A) in the removable cover
plates before they are knocked out. NB! Leave the rear plate
in the base (Fig. 18 D) in place when the cover plates are
knocked out.
3. Remove the rear plate (Fig. 18 D) in the base.
Fig. 19
4. Place the base in the correct position on the floor plate (if
any). Level the product using the 4 adjustment screws (Fig. 19 A).
5. Attach the base to the burn chamber using the 4 screws
(M8 x 30 mm) from the bag of screws (Fig. 19 B).
6. Carefully raise the product with the help of another person.
7. Adjust the glass door, if necessary, with the screws as shown
in Fig. 17 C. There must be an even gap between the door and
the base to allow the door to hang straight.
Fig. 20
8. Install the side glass panels by positioning them in the lower
glass clips (Fig. 20 A). Lift up the upper clips and press them
down onto the side glass. Make sure there is an even gap
between the side glass and the side plate at both the front
and back. Tighten the front screw for the side glass (Fig. 18 B).
The back screw (Fig. 18 C) should be loosened just sufficiently
to allow the glass clip to be raised without removing the
screw (this makes it easier if replacing the glass later on).
9. Pull the flex hose (if any) through a hole in the floor or rear
of the base (Fig. 18 A) and attach it to the outlet using a hose
clip. NB! Make sure the hose is long enough to make it
unnecessary to have any joints.
10. Replace the rear plate (Fig. 18 D).
11. The base area must be protected from heat radiation from
the product with the aid of the accompanying heat shield
(fig. 7 A). Fasten this with the 2 screws as shown in fig. 7 B.
Jøtul F 377 - with soapstone
Se separate installation manual (cat. no. 10043560).
ENGLISH
13