General; Safety Instructions - Artidor AR-021 Mode D'emploi

1.

General

Congratulations on your new explosion-safe AR-021 motion sensor. If you follow the
instructions in this user manual, your new motion sensor will give you years of enjoyment.
The Artidor motion sensor is based on the latest high frequent radar technology and
therefore capable of detecting even the slightest movements.
Thanks to the wide opening angle and its 8 m detection range, any movement is detected.
Even through doors, glass panes and thin walls, movements will be detected.
The sensor electronics offers an electrical output that can deliver up to 4.000 VA on resistive
or light inductive loads and an extra potential free contact. The intelligent, microprocessor-
based sensor technology switches the light ON and OFF again after the pre-set time. Most
convenient, safe and both energy and cost saving.
The motion sensor can successfully be applied in porches, circulation areas, staircases,
storerooms, cold storage rooms and business areas. The motion sensor meets the latest
explosion safety requirements and can be applied in a wide range of locations such as at oil
and gas production sites, in chemical and petrochemical industries, the pharmaceutical
industry and the food industry.
The Artidor motion sensor is certified in accordance with European Directive 2014/34/EU
(ATEX 114) for use in gas or dust hazardous areas and is CE marked.
2.

Safety Instructions

The AR-021 motion sensor is an explosion-safe product suitable for use in
hazardous areas with explosion hazard from flammable gases, vapors, mist
and dust, classified as Zone 2 or Zone 22.
This manual must be read and understood for safe use of the motion sensor. All warnings
and instructions must be followed.
•
Installation must be carried out by personnel trained and qualified in explosion safety
taking the instructions mentioned on the equipment and in this manual into
consideration. Local regulations that apply to the installation must be followed.
•
Connect this equipment to the supply voltage for which it is designed.
•
Isolate electrical power to the motion sensor before electrical installation.
•
The protection degree against ignition "Restricted Breathing" has been applied to the
apparatus. The enclosure may not be opened if the motion sensor is energized.
•
Installation of cables may not invalidate the protection degree "Restricted Breathing",
therefore only IP67 cable glands with the a clamping size meeting the cable diameter
should be used.
Installation manual AR-021 explosion-safe motion sensor
E
04-2022
5 / 44