Marking; Installation Instructions - Artidor AR-021 Mode D'emploi

6.

Marking

The motion sensor complies with the European Directives for EMC and ATEX and implicit to
the Low Voltage Directive. With regard to explosion safety the motion sensor has been
E
designed and manufactured on the basis of the essential health and safety requirements of
European Directive 2014/34/EU (ATEX 114) relating to Group II Category 3GD. Harmonized
European construction standards have been applied fulfilling the essential requirements of
the directives.
Example of an AR-021 motion sensor label.
7.

Installation instructions

•
Installation of explosion-safe equipment such as this product must be carried out by
personnel specially trained and qualified to do this, following the relevant requirements
of the installation standard EN 60079-14.
•
For the installation and use of this product the relevant safety regulations and also the
generally recognized latest state of the technology apply.
•
During assembly, care must be taken that the framework, screws and surface are strong
enough to take the weight of the motion sensor.
•
Isolate power from the electrical supply cable prior to installation.
•
Install the connection cable and make sure that it is protected from mechanical and
chemical influences.
•
Connect the end of the cable in a proper way to an external connection box and ensure
this is done professionally. The connection box is not supplied. Use a connection box
that it is suitably protected for the (explosion hazard) classification of the surroundings in
which it will be used.
Installation manual AR-021 explosion-safe motion sensor
8 / 44
04-2022