General - Artidor AR-024 Manuel D'installation

1.

General

The Artidor explosion-safe occupancy sensor AR-024 is based on passive infrared
technology and capable of detecting movements of heat sources. Thanks to the wide
opening angle and its 10 m range, this sensor is suitable for monitoring large areas.
The occupancy sensor is designed for use inside large buildings for example warehouses
and combines energy saving and the protection of the environment in addition to convenient
lighting.
Motion sensors switch the light depending on movements and the ambient light. The sensor
itself does not emit any radiation and is therefore called "passive". Unlike motion sensors,
occupancy sensors can also switch off lighting if there is sufficient daylight, because of their
advanced mixed light measurement (the principle on which occupancy sensors are based).
Do not install sensors near heat sources like air-conditioning units, lights or radiators. The
sensor electronics offers a potential free contact for switching up to 1,150 VA load.
The occupancy sensor is mounted on top a coated aluminum housing. The explosion safety
to gas and dust is arranged by the appliance of protection degrees against ignition
"Increased safety", "molding" and "protected by enclosure".
Installation manual AR-024 explosion-safe occupancy sensor
E
04-2022
5 / 44