Trouble Shooting - Artidor AR-024 Manuel D'installation

Mechanical alignment: The detection area is oval shaped. Install the unit in such a manner
that the markings on the housing are positioned in the longitudinal direction of the area to be
monitored. Do not install sensors near heat sources like air-conditioning units, lights or
E
radiators.
9.

Trouble shooting

The functional indicators in the case of the Artidor AR-024 (red and green LED's) have
several functions.
Red and green LED indicating self-checking mode (over a period of 60 seconds following
mains'-supply lock-on)
•
Flashing at intervals of 1 second
EEPROM / memory empty
•
Flashing rapidly
EEPROM / memory contains information
Red LED as an indicator of status
•
Flashing irregularly
Movements are detected within the area of coverage
•
Flashing regularly
Sensor identifies bright, light off (dependent upon operating mode)
•
Not illuminated
Sensor identifies dark, light on (dependent upon operating mode)
•
Flashing extremely rapidly
Too bright / Too dark / Undefined
Red LED as an acknowledgement of receipt for commands from the remote control
•
Illuminated for 1 seconds
Signal validly received
•
Illuminated for 0.25 seconds
Not-accepted command, sensor blocked
•
Flashing extremely rapidly
Not-accepted command, occurs, for example, when an attempt is made to set a twilight-
value that is too high or too low
Red LED as an acknowledgement of receipt for commands from the remote control
Installation manual AR-024 explosion-safe occupancy sensor
10 / 44
04-2022