Maintenance; Repair; Removal / Re-Use - Artidor AR-024 Manuel D'installation

•
Red and green LEDs flash 3x briefly every 5 seconds
Indicates semi-automatic mode
•
Red and green LEDs light up alternately
Determining the light value for automatic shutdown with sufficient daylight. (This is only
indicated with a set lag time of 30 minutes.)
10.

Maintenance

For the maintenance of the AR-024 occupancy sensor the requirements as stated in
EN 60079-17 apply. If the occupancy sensor is no longer in good condition, very dirty or
damaged, it must be repaired or cleaned immediately. The power supply to the occupancy
sensor must be switched off and may only be restored after the maintenance has been
carried out and approved.
The advised maintenance cycle for this occupancy sensor depends on its specific use and
must therefore be agreed upon with the user for the expected use.
11.

Repair

Repairs to the AR-024 occupancy sensor may only be executed by applying original parts
that are assessed, converted and marked by Artidor Explosion Safety B.V. Repairs may only
be carried out by qualified skilled workers who have been trained in accordance with
EN 60079-19. Applying of non-assessed, non-converted, non-marked parts may lead to
injury to persons and damage to equipment.
If non-original parts are used or repairs are carried out in an incompetent manner, the
explosion-safety of the occupancy sensor can no longer be guaranteed. Therefore it is
preferred that the occupancy sensor will be returned to the manufacturer or its representative
for repair.
If the housing is opened care must be taken of the following:
•
The housing must not be opened unless power is switched off prior to repair.
•
The housing must not be opened unless the area has been known to be non-hazardous.
•
If opened, the AR-024 occupancy sensor shall be dismantled in a logical sequence.
12.

Removal / re-use

For processing regarding disposal or reuse of the product and its packaging, national
disposal and environmental laws and legislation must be taken into consideration.
Alterations can be made to this user manual without notice.
Installation manual AR-024 explosion-safe occupancy sensor
E
04-2022
11 / 44