Velocity - WGP WORR MACHINE Manuel De L'utilisateur

II. P
REPARING fOR
• Paintball industry approved protective gear (for face and eyes) must be worn
at all times while operating and performing adjustments on this marker.
• Prior to beginning any work on your marker, check to make sure that all excess
pressure has been released by pointing the marker in a safe direction and pulling
the trigger. This is a necessary precaution due to the fact that the marker may
still contain pressure even after the removal of the gas source.
• Damages to the marker due to improper adjustments are NOT covered under
warranty. If you are uncertain, unable or do not know how to perform work on
the marker, have adjustments and repairs made by WGP.
III. V
ELOCITy
• If using the Worr Machine EG (Electronic) Marker, see E-Grip
instructions on the following page.
• To adjust the velocity, insert the velocity adjustment wrench
provided with your marker into the screw at the rear of the marker.
Turning the screw clockwise increases the markers velocity, turn-
ing it counterclockwise decreases the velocity.. Be sure to follow
all local and ASTM standard rules when adjusting your velocity.
Also make sure that you are always wearing paintball apporved
safety equipment when handling your marker.
WARNING:
WGP does not set the velocity prior to leaving the factory. You MUST set the velocity within field and
safety limits using a chronograph prior to playing. Always use a chronograph to verify that your mark-
ers velocity does not exceed maximum safety limits.
WORR MACHINE® MARKER OWNERS MANUAL
U (C .)
SAGE ONT