Worr Machine Eg (Electronic) - E-Grip Operation - WGP WORR MACHINE Manuel De L'utilisateur

WORR MACHINE® MARKER OWNERS MANUAL
IV. W M
ORR ACHINE
1. Eye Protection: Ensure all individuals within 200 yards are properly protected against
paintball impacts.
Engage Safety & Install Barrel Sleeve: Push Safety from left to right on marker; Red Band
2.
around the safety should not be showing if the safety is on. Properly Install Barrel Sleeve.
3. Install Battery: Remove three allen screws and remove right side grip cover and properly
install 9 volt battery.
4. Test for Power: To test for power press and hold down bottom button (below two lights
on back of grip) for approximately 2 seconds. 2 Green lights should be illuminated.
Hold down button until light goes out. Reinstall grip cover (Do Not Over-Tighten Screws).
V. W M
ORR ACHINE
M
ARKER
2 Green Lights
Indicates
Marker Is On.
NOTE:
The Electronic Anti-Chop Eye is in an Always On position and cannot be turned off.

EG (E
LECTRONIC
EG (E ) — O
LECTRONIC
O
N
) — E-G O
RIP PERATION
PERATION
b
ATTERy
Top Light Green,
Bottom Light Red
Indicates Marker Is On,
But Low On Battery.
L
OW